Differences

This shows you the differences between two versions of the page.

--- nas:zfs:replace_drive [2023/02/05 13:50] – created admin
+++ nas:zfs:replace_drive [2023/02/06 11:59] (current) – admin
@@ Line 21: / Line 21: @@
 ```bash
 zpool replace storage /dev/disk/by-id/ata-ST12000NM001G-2MV103_ZL21YC1S /dev/disk/by-id/ata-ST12000NM001G-2MV103_ZS806SKT
+```
+Example status output
+```
+  scan: resilver in progress since Sun Feb  5 19:28:46 2023
+.6G scanned at 1.51G/s, 7.15G issued at 563M/s, 41.6T total
+B resilvered, 0.02% done, 21:30:34 to go
+config:
+        NAME                                     STATE     READ WRITE CKSUM
+        storage                                  ONLINE       0     0     0
+          raidz1-0                               ONLINE       0     0     0
+            ata-ST12000NM0008-2H3101_ZHZ4LWL0    ONLINE       0     0     0
+            ata-ST12000NM0008-2H3101_ZHZ5HTAQ    ONLINE       0     0     0
+            ata-ST12000NM0008-2H3101_ZHZ6H0PS    ONLINE       0     0     0
+            replacing-3                          ONLINE       0     0     0
+              ata-ST12000NM001G-2MV103_ZL21YC1S  ONLINE       0     0     0
+              ata-ST12000NM001G-2MV103_ZS806SKT  ONLINE       0     0     0
+            ata-ST12000NM001G-2MV103_ZL25ZSXG    ONLINE       0     0     0
+            ata-ST12000NM001G-2MV103_ZL26VRV0    ONLINE       0     0     0
+        logs
+          nvme0n1p2                              ONLINE       0     0     0
+```
+The time in `scan:` is only a rough estimate and depends on how much work is already done.
+E. g. after over 24h in can look something like:
+```
+  scan: resilver in progress since Sun Feb  5 19:28:46 2023
+.6T scanned at 558M/s, 27.7T issued at 489M/s, 41.6T total
+.48T resilvered, 66.66% done, 08:15:18 to
 ```