Projekte - network:ipv6

podman_publish_and_ipv6

Anonymous (anonymous@undisclosed.example.com) — 2023-06-12T22:11:32+00:00

Podman, publish and IPv6 There are two ways described here to publish IPv6 ports from root started podman containers. * Add --network slirp4netns:port_handler=rootlesskit e.g. sudo podman run --network slirp4netns:port_handler=rootlesskit -p 8080:80 docker.io/nginx

set_a_static_address_part_with_ipv6_and_debian_ifupdown

Anonymous (anonymous@undisclosed.example.com) — 2023-08-03T18:35:40+00:00

Set a static address part with IPv6 and Debian ifupdown In /etc/network/interfaces configure the inet6 stanza like this: iface eth0 inet6 auto pre-up ip token set ::251 dev eth0 Then restart the interface if needed: ifdown eth0; sleep 5; ifup eth0

set_a_static_address_part_with_ipv6_and_networkmanager

Anonymous (anonymous@undisclosed.example.com) — 2023-08-03T18:41:28+00:00

Set a static address part with IPv6 and NetworkManager In /etc/netplan/00-.yaml configure a ipv6-address-token like this: sudo nmcli con mod 'Common net' ipv6.addr-gen-mode eui64 sudo nmcli con mod 'Common net' ipv6.token ::252 Then restart the interface if needed:

set_a_static_address_part_with_ipv6_and_systemd-networkd

Anonymous (anonymous@undisclosed.example.com) — 2023-07-19T21:18:44+00:00

Set a static address part with IPv6 and systemd-networkd In a eth0.network there is one setting that provides the host part of the IPv6 Address. When the prefix part changes this is propagated correctly. [Network] DHCP=yes DNSSEC=no # set your identifier for the computer here IPv6Token=::235

set_a_static_address_part_with_ipv6_and_ubuntu_netplan

Anonymous (anonymous@undisclosed.example.com) — 2023-08-03T18:39:24+00:00

Set a static address part with IPv6 and Ubuntu netplan In /etc/netplan/00-.yaml configure a ipv6-address-token like this: addresses: - 192.168.1.250/24 ipv6-address-token: ::250 Then restart the interface if needed: